105
105
<dd>Print a variety of system state variables, i.e., state related to the local server. All except the last four lines are described in the NTP Version 3 specification, RFC-1305.
106
106
<p>The <tt>system flags</tt> show various system flags, some of which can be set and cleared by the <tt>enable</tt> and <tt>disable</tt> configuration commands, respectively. These are the <tt>auth</tt>, <tt>bclient</tt>, <tt>monitor</tt>, <tt>pll</tt>, <tt>pps</tt> and <tt>stats</tt> flags. See the <tt>ntpd</tt> documentation for the meaning of these flags. There are two additional flags which are read only, the <tt>kernel_pll</tt> and <tt>kernel_pps</tt>. These flags indicate the synchronization status when the precision time kernel modifications are in use. The <tt>kernel_pll</tt> indicates that the local clock is being disciplined by the kernel, while the kernel_pps indicates the kernel discipline is provided by the PPS signal.</p>
107
<p>The <tt>stability</tt> is the residual frequency error remaining afterthe system frequency correction is applied and is intended for maintenance and debugging. In most architectures, this value will initially decrease from as high as 500 ppm to a nominal value in the range .01 to 0.1 ppm. If it remains high for some time after starting the daemon, something may be wrong with the local clock, or the value of the kernel variable <tt>tick</tt> may be incorrect.</p>
107
<p>The <tt>stability</tt> is the residual frequency error remaining after the system frequency correction is applied and is intended for maintenance and debugging. In most architectures, this value will initially decrease from as high as 500 ppm to a nominal value in the range .01 to 0.1 ppm. If it remains high for some time after starting the daemon, something may be wrong with the local clock, or the value of the kernel variable <tt>tick</tt> may be incorrect.</p>
108
108
<p>The <tt>broadcastdelay</tt> shows the default broadcast delay, as set by the <tt>broadcastdelay</tt> configuration command.</p>
109
109
<p>The <tt>authdelay</tt> shows the default authentication delay, as set by the <tt>authdelay</tt> configuration command.</p>