* New upstream version - They no longer ship arlib, adjust dfsg.patch. - Drop kfreebsd.patch, applied upstream - Update patches for upstream changes. * Remove the obsolete config files:
for ntp: - /etc/logcheck/ignore.d.server/ntp, removed in 1:4.2.6+dfsg-1 - /etc/dhcp3/dhclient-enter-hooks.d/ntp, replaced by exit hooks in 1:4.2.4p4+dfsg-3 - /etc/network/if-up.d/ntp, removed in 1:4.2.4p0+dfsg-1
for ntpdate: - /etc/dhcp3/dhclient-enter-hooks.d/ntpdate, replaced by exit hooks in 1:4.2.4p4+dfsg-3
Use dpkg 1.15.7.2's dpkg-maintscript-helper. This needs a Pre-Depends to work, else it's never going to be removed. (Closes: #569530) * Add "Depends: ${misc:Depends}" to ntp-doc.
<p>The Count Field displays the number of events since the last time the code changed. Upon reaching 15, subsequent events with the same code are ignored. The Event Field displays the most recent event message coded as follows:</p>
176
<p>The Count Field displays the number of events since the last time the code changed. Upon reaching 15, subsequent events with the same code are ignored.</p>
177
178
<p>The Event Field displays the most recent event message coded as follows:</p>
<p>The peer status word consists of four fields: Status (0-4, Select (5-7), Count (8-11) and Code (12-15). It is reported in the first line of the <tt>rv <i>associd</i></tt> display produced by the <tt>ntpq</tt> program.</p>
293
<p>The peer status word consists of four fields: Status (0-4), Select (5-7), Count (8-11) and Code (12-15). It is reported in the first line of the <tt>rv <i>associd</i></tt> display produced by the <tt>ntpq</tt> program.</p>
<p>The Status Field displays the peer status code bits in hexadecimal as follows:</p>
306
<p>The Status Field displays the peer status code bits in hexadecimal; each bit is an independent flag. (Note this field is 5 bits wide, and combines with the the 3-bit-wide Select Field to create the first full byte of the peer status word.) The meaning of each bit in the Status Field is listed in the following table:</p>
<p>The Select Field displays the current selection. status The T Field displays the tally codes beginning the <tt>ntpq peers</tt> display. The values are coded as follows:</p>
348
<p>The Select Field displays the current selection status. (The T Field in the following table gives the corresponding tally codes used in the <tt>ntpq peers</tt> display.) The values are coded as follows:</p>
<p>The Count Field displays the number of events since the last time the code changed. Upon reaching 15, subsequent events with the same code are ignored. The Event Field displays the most recent event message coded as follows:</p>
417
<p>The Count Field displays the number of events since the last time the code changed. Upon reaching 15, subsequent events with the same code are ignored. </p>
418
419
<p>The Event Field displays the most recent event message coded as follows:</p>