1
/* inflate9.h -- internal inflate state definition
2
* Copyright (C) 1995-2003 Mark Adler
3
* For conditions of distribution and use, see copyright notice in zlib.h
6
/* WARNING: this file should *not* be used by applications. It is
7
part of the implementation of the compression library and is
8
subject to change. Applications should only use zlib.h.
11
/* Possible inflate modes between inflate() calls */
13
TYPE, /* i: waiting for type bits, including last-flag bit */
14
STORED, /* i: waiting for stored size (length and complement) */
15
TABLE, /* i: waiting for dynamic block table lengths */
16
LEN, /* i: waiting for length/lit code */
17
DONE, /* finished check, done -- remain here until reset */
18
BAD /* got a data error -- remain here until reset */
22
State transitions between above modes -
24
(most modes can go to the BAD mode -- not shown for clarity)
27
TYPE -> STORED or TABLE or LEN or DONE
29
TABLE -> LENLENS -> CODELENS -> LEN
34
/* state maintained between inflate() calls. Approximately 7K bytes. */
35
struct inflate_state {
37
unsigned char FAR *window; /* allocated sliding window, if needed */
38
/* dynamic table building */
39
unsigned ncode; /* number of code length code lengths */
40
unsigned nlen; /* number of length code lengths */
41
unsigned ndist; /* number of distance code lengths */
42
unsigned have; /* number of code lengths in lens[] */
43
code FAR *next; /* next available space in codes[] */
44
unsigned short lens[320]; /* temporary storage for code lengths */
45
unsigned short work[288]; /* work area for code table building */
46
code codes[ENOUGH]; /* space for code tables */