8
8
The default width is set by the Arcs Preferences (in menu <B>File / Preferences...</B>, "General" section, "Arcs" tab).
9
9
If there are other arcs of this type already connected to the new one,
10
10
and they are wider than normal, then the new arc will use that width.
11
Also, if an arc connects to a node that is wider than normal, it will grow to match the size of the node
12
14
Note that all arcs overlap their endpoint by half of their width,
13
15
so very wide arcs may overlap their destination with too much geometry.