2
oss_digi96 - RME Digi96 professional audio driver.
5
Audio driver for the RME Digi96 family of profressional audio controllers.
6
- Only 16 and 24/32 bit audio formats are supported.
7
- All Digi96 family members support 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz and
13
Note! For recording you need to set digi96.sync to INTERNAL and the values
14
of digi96.mode and digi96.input to match your studio setup. Otherwise
15
recordings will fail with I/O error.
17
There are several settings that can be changed using the ossmix program
18
shipped with OSS. Note that some features don't work with all Digi96
19
family members. For example ADAT mode is not supported by the base
22
o digi96.mode <SPDIF|AESEBU|ADAT>:
23
This setting controls the output mode which can be S/PDIF (consumer),
24
AES/EBU (professional) or ADAT. The input mode is detected automatically.
25
If ADAT input is detected the output mode will be switched to ADAT
26
automatically (this doesn't work in the other direction).
28
o digi96.sync <EXTERNAL|INTERNAL>:
29
This setting tells if the playback sampling rate is based on the internal
30
oscillator or the sample rate detected in the input port. See also the
31
definition of the digi96.worldclk setting.
33
o digi96.input <OPTICAL|COAXIAL|INTERNAL|XLR>: Selects the active input.
35
o digi96.sel <BYPASS|NORMAL>:
36
When set to BYPASS the input signal will be routed directly to the
37
output (also sets digi96.sync automatically to EXTERNAL). In this mode
38
audio data written to /dev/dsp will be muted.
40
o digi96.worldclk ON|OFF:
41
Setting this control to ON will enable the optional worldclock input as
42
the sample rate source (overrides the digi96.sync setting).
45
Enables/disables the de-emphasis option on the analog (monitor) output
48
o digi96.data <AUDIO|AC3>:
49
Specifies if the output signal is audio or AC3 data (sets the non-audio
50
bit in the channel status data).
57
CONFIGFILEPATH/oss_digi96.conf Device configuration file