1
# Configuration for getaddrinfo(3).
3
# So far only configuration for the destination address sorting is needed.
4
# RFC 3484 governs the sorting. But the RFC also says that system
5
# administrators should be able to overwrite the defaults. This can be
8
# All lines have an initial identifier specifying the option followed by
9
# up to two values. Information specified in this file replaces the
10
# default information. Complete absence of data of one kind causes the
11
# appropriate default information to be used. The supported commands include:
14
# If set to yes, each getaddrinfo(3) call will check whether this file
15
# changed and if necessary reload. This option should not really be
16
# used. There are possible runtime problems. The default is no.
18
# label <mask> <value>
19
# Add another rule to the RFC 3484 label table. See section 2.1 in
20
# RFC 3484. The default is:
26
#label ::ffff:0:0/96 4
31
# This default differs from the tables given in RFC 3484 by handling
32
# (now obsolete) site-local IPv6 addresses and Unique Local Addresses.
33
# The reason for this difference is that these addresses are never
34
# NATed while IPv4 site-local addresses most probably are. Given
35
# the precedence of IPv6 over IPv4 (see below) on machines having only
36
# site-local IPv4 and IPv6 addresses a lookup for a global address would
37
# see the IPv6 be preferred. The result is a long delay because the
38
# site-local IPv6 addresses cannot be used while the IPv4 address is
39
# (at least for the foreseeable future) NATed. We also treat Teredo
42
# precedence <mask> <value>
43
# Add another rule to the RFC 3484 precedence table. See section 2.1
44
# and 10.3 in RFC 3484. The default is:
46
#precedence ::1/128 50
48
#precedence 2002::/16 30
50
#precedence ::ffff:0:0/96 10
52
# For sites which prefer IPv4 connections change the last line to
54
#precedence ::ffff:0:0/96 100
57
# scopev4 <mask> <value>
58
# Add another rule to the RFC 3484 scope table for IPv4 addresses.
59
# By default the scope IDs described in section 3.2 in RFC 3484 are
60
# used. Changing these defaults should hardly ever be necessary.
61
# The defaults are equivalent to:
63
#scopev4 ::ffff:169.254.0.0/112 2
64
#scopev4 ::ffff:127.0.0.0/104 2
65
#scopev4 ::ffff:10.0.0.0/104 5
66
#scopev4 ::ffff:172.16.0.0/108 5
67
#scopev4 ::ffff:192.168.0.0/112 5
68
#scopev4 ::ffff:0.0.0.0/96 14