2
* ALPHAPROJECT AP-SH4AD-0A Support.
4
* Copyright (C) 2010 ALPHAPROJECT Co.,Ltd.
5
* Copyright (C) 2010 Matt Fleming
6
* Copyright (C) 2010 Paul Mundt
8
* This file is subject to the terms and conditions of the GNU General Public
9
* License. See the file "COPYING" in the main directory of this archive
12
#include <linux/init.h>
13
#include <linux/platform_device.h>
15
#include <linux/smsc911x.h>
16
#include <linux/irq.h>
17
#include <linux/clk.h>
18
#include <asm/machvec.h>
19
#include <asm/sizes.h>
21
static struct resource smsc911x_resources[] = {
23
.name = "smsc911x-memory",
25
.end = 0xA4000000 + SZ_256 - 1,
26
.flags = IORESOURCE_MEM,
29
.name = "smsc911x-irq",
30
.start = evt2irq(0x200),
31
.end = evt2irq(0x200),
32
.flags = IORESOURCE_IRQ,
36
static struct smsc911x_platform_config smsc911x_config = {
37
.irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
38
.irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
39
.flags = SMSC911X_USE_16BIT,
40
.phy_interface = PHY_INTERFACE_MODE_MII,
43
static struct platform_device smsc911x_device = {
46
.num_resources = ARRAY_SIZE(smsc911x_resources),
47
.resource = smsc911x_resources,
49
.platform_data = &smsc911x_config,
53
static struct platform_device *apsh4ad0a_devices[] __initdata = {
57
static int __init apsh4ad0a_devices_setup(void)
59
return platform_add_devices(apsh4ad0a_devices,
60
ARRAY_SIZE(apsh4ad0a_devices));
62
device_initcall(apsh4ad0a_devices_setup);
64
static int apsh4ad0a_mode_pins(void)
68
/* These are the factory default settings of SW1 and SW2.
69
* If you change these dip switches then you will need to
70
* adjust the values below as well.
72
value |= MODE_PIN0; /* Clock Mode 3 */
76
value &= ~MODE_PIN4; /* 16-bit Area0 bus width */
79
value |= MODE_PIN7; /* Normal mode */
80
value |= MODE_PIN8; /* Little Endian */
81
value |= MODE_PIN9; /* Crystal resonator */
82
value &= ~MODE_PIN10; /* 29-bit address mode */
83
value &= ~MODE_PIN11; /* PCI-E Root port */
84
value &= ~MODE_PIN12; /* 4 lane + 1 lane */
85
value |= MODE_PIN13; /* AUD Enable */
86
value &= ~MODE_PIN14; /* Normal Operation */
91
static int apsh4ad0a_clk_init(void)
96
clk = clk_get(NULL, "extal");
97
if (!clk || IS_ERR(clk))
99
ret = clk_set_rate(clk, 33333000);
105
/* Initialize the board */
106
static void __init apsh4ad0a_setup(char **cmdline_p)
108
pr_info("Alpha Project AP-SH4AD-0A support:\n");
111
static void __init apsh4ad0a_init_irq(void)
113
plat_irq_setup_pins(IRQ_MODE_IRQ3210);
119
static struct sh_machine_vector mv_apsh4ad0a __initmv = {
120
.mv_name = "AP-SH4AD-0A",
121
.mv_setup = apsh4ad0a_setup,
122
.mv_mode_pins = apsh4ad0a_mode_pins,
123
.mv_clk_init = apsh4ad0a_clk_init,
124
.mv_init_irq = apsh4ad0a_init_irq,