2
* (C) Copyright 2013 Keymile AG
3
* Valentin Longchamp <valentin.longchamp@keymile.com>
5
* SPDX-License-Identifier: GPL-2.0+
14
int board_eth_init(bd_t *bis)
17
#ifdef CONFIG_FMAN_ENET
18
struct fsl_pq_mdio_info dtsec_mdio_info;
20
printf("Initializing Fman\n");
22
dtsec_mdio_info.regs =
23
(struct tsec_mii_mng *)CONFIG_SYS_FM1_DTSEC1_MDIO_ADDR;
24
dtsec_mdio_info.name = DEFAULT_FM_MDIO_NAME;
26
/* Register the real 1G MDIO bus */
27
fsl_pq_mdio_init(bis, &dtsec_mdio_info);
29
/* DTESC1/2 don't have a PHY, they are temporarily disabled
30
* so that u-boot doesn't try to unsuccessfuly enable them */
31
fm_disable_port(FM1_DTSEC1);
32
fm_disable_port(FM1_DTSEC2);
35
* Program RGMII DTSEC5 (FM1 MAC5) on the EC2 physical itf
36
* This is the debug interface, the only one used in u-boot
38
fm_info_set_phy_address(FM1_DTSEC5, CONFIG_SYS_FM1_DTSEC5_PHY_ADDR);
39
fm_info_set_mdio(FM1_DTSEC5,
40
miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME));
42
ret = cpu_eth_init(bis);
44
/* reenable DTSEC1/2 for later (kernel) */
45
fm_enable_port(FM1_DTSEC1);
46
fm_enable_port(FM1_DTSEC2);
52
#if defined(CONFIG_PHYLIB) && defined(CONFIG_PHY_MARVELL)
54
#define mv88E1118_PAGE_REG 22
56
int board_phy_config(struct phy_device *phydev)
58
if (phydev->addr == CONFIG_SYS_FM1_DTSEC5_PHY_ADDR) {
59
/* driver config is good */
60
if (phydev->drv->config)
61
phydev->drv->config(phydev);
63
/* but we still need to fix the LEDs */
64
phy_write(phydev, MDIO_DEVAD_NONE, mv88E1118_PAGE_REG, 0x0003);
65
phy_write(phydev, MDIO_DEVAD_NONE, 0x10, 0x0840);
66
phy_write(phydev, MDIO_DEVAD_NONE, mv88E1118_PAGE_REG, 0x0000);