1
Exynos Display Controller
2
=========================
5
compatible: should be "samsung,exynos-fimd"
6
reg: Base address of FIMD IP.
9
samsung,vl-col: X resolution of the panel
10
samsung,vl-row: Y resolution of the panel
11
samsung,vl-freq: Refresh rate
12
samsung,vl-bpix: Bits per pixel
13
samsung,vl-hspw: Hsync value
14
samsung,vl-hfpd: Right margin
15
samsung,vl-hbpd: Left margin
16
samsung,vl-vspw: Vsync value
17
samsung,vl-vfpd: Lower margin
18
samsung,vl-vbpd: Upper margin
21
Board(panel specific):
22
samsung,vl-width: width of display area in mm
23
samsung,vl-height: Height of display area in mm
25
samsung,vl-clkp: Clock polarity
26
CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
27
samsung,vl-oep: Output Enable polarity
28
CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
29
samsung,vl-hsp: Horizontal Sync polarity
30
CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
31
samsung,vl-vsp: Vertical Sync polarity
32
CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
33
samsung,vl-dp: Data polarity
34
CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
36
samsung,vl-cmd-allow-len: Wait end of frame
37
samsung,winid: Window number on which data is to be displayed
38
samsung,init-delay: Delay before LCD initialization starts
39
samsung,power-on-delay: Delay after LCD is powered on
40
samsung,reset-delay: Delay after LCD is reset
41
samsung,interface-mode: 1(FIMD_RGB_INTERFACE), 2(FIMD_CPU_INTERFACE)
42
samsung,mipi-enabled: 1 if you want to use MIPI, else 0
43
samsung,dp-enabled: 1is you want to use DP, else 0
44
samsung,cs-setup: cs_setup value in FIMD_CPU_INTERFACE mode.
45
samsung,wr-setup: wr_setup value in FIMD_CPU_INTERFACE mode.
46
samsung,wr-act: wr_act value in FIMD_CPU_INTERFACE mode.
47
samsung,wr-hold: wr_hold value in FIMD_CPU_INTERFACE mode.
48
samsung,logo-on: 1 if you want to use custom logo.
49
0 if you want LCD console.
50
samsung,logo-width: pixel width of logo image. Valid if logo_on = 1
51
samsung,logo-height: pixel height of logo image. Valid if logo_on = 1
52
samsung,logo-addr: Address of logo image. Valid if logo_on = 1
53
samsung,rgb-mode: 0(MODE_RGB_P), 1(MODE_BGR_P),
54
2(MODE_RGB_S), 3(MODE_BGR_S)
55
samsung,pclk-name: parent clock identifier: 1(MPLL), 2(EPLL), 3(VPLL)
56
samsung,sclk-div: parent_clock/source_clock ratio
57
samsung,dual-lcd-enabled: 1 if you support two LCD, else 0
62
compatible = "samsung,exynos-fimd";
63
reg = <0x14400000 0x10000>;
70
samsung,vl-freq = <60>;
71
samsung,vl-col = <2560>;
72
samsung,vl-row = <1600>;
73
samsung,vl-width = <2560>;
74
samsung,vl-height = <1600>;
78
samsung,vl-bpix = <4>;
80
samsung,vl-hspw = <32>;
81
samsung,vl-hbpd = <80>;
82
samsung,vl-hfpd = <48>;
83
samsung,vl-vspw = <6>;
84
samsung,vl-vbpd = <37>;
85
samsung,vl-vfpd = <3>;
86
samsung,vl-cmd-allow-len = <0xf>;
89
samsung,interface-mode = <1>;
90
samsung,dp-enabled = <1>;
91
samsung,dual-lcd-enabled = <0>;